Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.

February 24 2017

5738 c885 500

--exiledsurfer on Twitter

March 29 2015

--MacLemon on Twitter
Reposted frommetalab metalab
Hackathon day 1 log: Printing a Capybara with our new 3d-printing setup.
Reposted frommetalab metalab

March 10 2015

3614 da76 500
Wheel and Tire for our Roomba (thingiverse: http://www.thingiverse.com/thing:715943 )
Reposted bym68kalphabetmetalab
1033 1f14 500
3030 85a4 500
Our Roomba has a new wheel.
Reposted bysydnormetalabalphabet

March 05 2015

--lumbric on Twitter
Reposted bymetalab metalab

February 01 2015

--derreisende on Twitter
Reposted bycliffordmetalabsydnorderreisendeleyrer

December 22 2014

4836 de88 500
The J-Head (aka "Hot End") needs maintenance. Filament is stuck and nothing is extruded.
3968 9892 500
The disassembled J-Head. You can see the rest of the filament which didn't come out when the nozzle was heated up and the filament was removed.
Reposted bymetalab metalab
3844 d6fa 500
Nozzle is fixed in vice for heating op and melting the clogged PLA. grip only a small corner of the nozzle, the vice is a very good heat sink. Connect the heating element and the thermistor to the electronics and heat the nozzle with printrun.
Reposted bymetalab metalab
3079 f757 500
The heated PLA expands and comes out the top instead of flowing through the nozzle. This is a clue, that the nozzle is clogged. We cleaned the melting chamber and the nozzle with a piece of 0,3 mm wire.
2545 122c 500
Cleaned-out nozzle, threading is sealed with PTFE tape to prevent leaking of molten material.
Reposted bymetalab metalab
2147 d3d0 500
Cleaned and re-assembled J-Head, you can see the red PTFE lining through the hollow lock set screw.
1052 4949 500
Re-assembled extruder drive with cleaned hobbed bolt.
Reposted bymetalab metalab
3499 aff8 500
Re-assembled extruder, ready to be installed.
3102 a755 500
Put the extruder back on the X-carriage. Prepare winged nuts for attaching.

December 21 2014

8079 293f 500
When attaching the extruder assembly to the X-carriage make sure that the winged nut is parallel to the edge when tightened. If not, unscrew it and retry with a different starting position.
6585 6708 500
Damaged slot for attaching the fan assembly to the X-axis carriage.
6329 7c47 500
When attaching the fan assembly to the X-axis carriage just tighten the screws lightly or this will happen.
Reposted bymetalab metalab
Older posts are this way If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.

Don't be the product, buy the product!