Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.

December 22 2014

3079 f757 500
The heated PLA expands and comes out the top instead of flowing through the nozzle. This is a clue, that the nozzle is clogged. We cleaned the melting chamber and the nozzle with a piece of 0,3 mm wire.
2545 122c 500
Cleaned-out nozzle, threading is sealed with PTFE tape to prevent leaking of molten material.
Reposted bymetalab metalab
2147 d3d0 500
Cleaned and re-assembled J-Head, you can see the red PTFE lining through the hollow lock set screw.
1052 4949 500
Re-assembled extruder drive with cleaned hobbed bolt.
Reposted bymetalab metalab
3499 aff8 500
Re-assembled extruder, ready to be installed.
3102 a755 500
Put the extruder back on the X-carriage. Prepare winged nuts for attaching.

December 21 2014

8079 293f 500
When attaching the extruder assembly to the X-carriage make sure that the winged nut is parallel to the edge when tightened. If not, unscrew it and retry with a different starting position.
6585 6708 500
Damaged slot for attaching the fan assembly to the X-axis carriage.
6329 7c47 500
When attaching the fan assembly to the X-axis carriage just tighten the screws lightly or this will happen.
Reposted bymetalab metalab
6166 3cd9 500
When attaching the fan assembly make sure that the toothed belt runs freely.

October 02 2014

4938 6f9e
Reposted bymetalabweltensturmstrohmiSpinNE555nibblerInteSakerosninnghizidhalathea
2685 7351 500
Reposted bymetalab metalab
2446 63ee 500
2398 13ef 500
Reposted bynicklesssofias
2304 ac4a 500
2225 6d28 500
Reposted bysofias sofias
2188 3558 500
Reposted bymetalabsydnorWallaruskrybusnicklessshallow
1234 4740 500
Reposted bymetalab metalab
Older posts are this way If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.

Don't be the product, buy the product!

Schweinderl